Siemens SIMOTION C 230-2 Operating Instructions Manual page 77

The following table describes the states of the enables and outputs in the respective SIMOTION
C operating states with an open or closed READY contact.
Table 4-19
Status of the READY
Open
Closed
Additional references
You can find information about TO outputCam and TO measuringInput in the SIMOTION Output
Cams and Measuring Inputs Function Manual.
SIMOTION C
Operating Instructions, 11/2022, A5E33441428B
States of enable signals and outputs:
SIMOTION C
contact
• During ramp-up
• During memory reset
• With fault condition
• In STOP state
• In STOPU state
• in RUN state
Status of enable signals and outputs:
• Controller enable deactivated
• Analog outputs at 0 V
• Digital outputs deactivated
Enable signals and outputs controlled by user pro‐
gram and technology
Interfaces
4.8 I/O interface
77