Configuring The Electrical Installation - Siemens SIMOTION C 230-2 Operating Instructions Manual

Hide thumbs Also See for SIMOTION C 230-2:
Table of Contents

Advertisement

Connecting
6.1 Wiring
6.1.2

Configuring the electrical installation

General rules for operating a SIMOTION C
You must observe the following primary rules for integrating a SIMOTION C in an automation
system or plant.
System startup after certain events
The following table identifies considerations required for startup of a system following certain
events.
Table 6-1
Startup after voltage drop or power
failure
Startup after releasing the EMERGEN‐
CY STOP apparatus
Supply voltage
The following table identifies the considerations required for the supply voltage.
Table 6-2
Stationary systems without all-pole
power disconnect switches
Load power supply, power supply
modules
All electric circuits
24 VDC supply
The following table identifies the considerations required for the 24 V supply.
Table 6-3
buildings
24 V DC supply lines, signal lines
24 V supply
92
System startup
If there is ...
Supply voltage
Scope
24 V supply
Scope
external lightning protection.
internal lightning protection
Safe (electrical) isolation of extra-low voltage
All hazardous operating conditions must be avoided. If necessa‐
ry, force an EMERGENCY STOP.
must always be controlled and defined.
Requirement
A power disconnect switch or a fuse must be provided in the
electrical installation for the building.
The set rated voltage range corresponds to the local supply volt‐
age.
The fluctuation/deviation of the supply voltage from the rated
value must be within the permissible tolerance (see Technical
data for S7-300 modules).
Requirement
Operating Instructions, 11/2022, A5E33441428B
Then ...
Take lightning protection meas‐
ures
(e.g. lightning conductors).
SIMOTION C

Advertisement

Table of Contents
loading

This manual is also suitable for:

Simotion c240Simotion c240 pn

Table of Contents