Siemens SIMOTION C 230-2 Operating Instructions Manual page 135

Symbolic assignment is not available for this application.
The following figure shows the default start addresses of the onboard drive interface of the
C230-2/C240.
Figure 7-7
An available encoder input of an axis channel (e.g. for a speed-controlled axis) can be used as
an input for a 16-bit up/down counter (90-degree pulse train of a connected TTL encoder, zero
pulse not required). The counter value can be accessed by means of an I/O variable (default start
address of the axis channel). Symbolic assignment is not available for this application.
The following figure shows the default start addresses of the onboard measuring system
interface of the C230-2/C240.
SIMOTION C
Operating Instructions, 11/2022, A5E33441428B
7.5 Addressing the onboard drive and measuring system interface of the C230-2, C240
Addressing the onboard drive interface
Addressing
135