Siemens SIMOTION C 230-2 Operating Instructions Manual page 164

Technical data
11.1 Technical data
System clocks
Interpolator cycle clock (IPO cycle clock)
Send cycle of PROFINET (C240 PN)
A modification can be made in the engineering system.
For system cycle clock settings, refer to the SIMOTION SCOUT online help.
Note
With the SIMOTION C, errors can occur during Download or during the transition from STOP
to RUN if I/O bus modules and a system cycle clock > 8 ms (only with equidistant bus cycle) are
used. If an error occurs, set the system cycle clock ≤ 8 ms.
DP slave connections
Table 11-4
Number of DP slave connections
PROFINET device connections
Table 11-5
Number of PROFINET device connections
Address areas
Table 11-6
Input address area, total
Output address area, total
Process image inputs
Process image outputs
Connection values
Table 11-7
Supply voltage
Power consumption from 24 V
Power loss
164
Number of DP slave connections
Number of PROFINET device connections
Address areas
Connection values
C230-2 C240
≥ 1.5 ms
- -
Max. 64
Max. 64
• 2 Kbytes for C230-2
• 4 Kbytes for C240 / C240 PN
• 2 Kbytes for C230-2
• 4 Kbytes for C240 / C240 PN
64 bytes
64 bytes
24 V DC (permissible range: 20.4 to 28.8 V)
• typically 0.9 A (inputs/outputs open)
• typically 1.2 A (with 4 encoders, 5 V)
• typically 1.9 A (with 4 encoders, 24 V)
15 W
Operating Instructions, 11/2022, A5E33441428B
C240 PN
≥ 0.5 ms
0.5 to 4 ms
SIMOTION C