Setting Up Your System
Connecting the Hardware
Connecting the Hardware
The software must be installed before you install the hardware. If your system
includes 86154A option 010, a laptop computer, or 86154A option 030, a pen
tablet computer, the software was factory-installed. Otherwise, refer to
"Installing the Software" on page 11
Table 2-1
combination systems with most types of GPS. If you have a GPS that is not
listed, use
to the pin-out illustration
page
Table 2-1 GPS System Configurations
.
If You Have This
Trimble Placer GPS/DR
Trimble Placer GPS 455
Trimble Placer 455 & Differential
Trimble Placer GPS 455 with
Dead Reckoning
Internal GPS & Differential
Trimble Placer GPS 400 or
SVeeSix
NOTE
Your system can be configured using either Agilent Technologies supplied
options or customer-supplied components.
Agilent Wireless Solutions
directs you to the configuration instructions for receiver, phone, and
Table 2-1
to find the one that most resembles your own. Also refer
"RS-232 to GPS Unit Cable Configuration" on
110.
with Receiver
Only
page 28
page 36
page 40
page 46
page 44
page 32
for instructions.
with Phone Only
page 72
page 80
page 84
page 88
page 76
with Receiver
and Phone
page 50
page 58
page 62
page 68
page 66
page 54
25