Testing the Signal
NOTE
Passing the Test
Verifying the System
Method 2: Measuring a Known Channel in the System
Do This
In the Markers group, click Add and To Max.
Wait for at least one minute before using the displayed marker value. The
system is set to display a running average of 32. With time, the marker value
will approach the value of the measured signal.
If the signal trace is of an acceptable amplitude above the noise floor,
depending on the distance from transmitters and antenna placement, at the
appropriate frequency for the channel measured, the system passed the test.
Now continue with the
Procedure" on page
152. If you are having problems with setting up these
tests, refer to
"Solving Problems and Updating Your System" on page 157
additional information.
146
See This
The level and frequency are displayed at the top-
left corner of the Spectrum display.
"Method 4: GPS Measurement Verification
for
Agilent Wireless Solutions