Modulation Cords - E-Mu ProteusX Operation Manual

6 - Voice Editor / Synthesizer Level

Modulation Cords

Modulation Cords
Each voice contains 36 Cords which are used to route modulation sources to destina-
tions and control the amount of modulation. There are only three permanently
connected modulation connections: amp envelope-to-amplifier, pitch wheel-to-pitch,
and key-to-pitch. All other modulation routings must be connected with a Cord.
Cord
Sources
Modulation
Source
LFO 1
Tremolo is created by routing an LFO to the Amp Volume using a Cord.
Modulation Sources
Source Description
Crossfade Random Generates the same random value for all voices in a preset. This
source is intended to be used for crossfading voices.
Key (+, ~) Key Tracking - This value increases as you play up the keyboard.
Velocity (+, ~, -) Key Velocity - This value increases as the key is played harder.
Release Velocity This value increases the slower you release the key
Gate This value goes to full value as long as a key is depressed.
Pitch Wheel MIDI data from your keyboard' s pitch bender.
92
Cord Page Select Buttons
Modulation Amounts
Amount +/-
-
+
Cord
Destinations
Destination
Amp
Volume
Proteus X Operation Manual