Channel Ramp; Preset Patchcords - E-Mu ProteusX Operation Manual

5 - Preset Editor
Preset Globals

Channel Ramp

This processor generates a single negative going slope whenever the first key is
depressed on the MIDI channel. This preset level processor was originally
designed to simulate the percussion key click on Hammond organs, but you may
find other uses.
Channel Ramp
time
1st Note
Played
The Channel Ramp instantly resets when all notes have been released and the
next first key on the MIDI channel is pressed. The value of the ramp rate sets the
increment. Large values produce fast ramps and small values produce slow ramps.
To use the Channel Ramp as a first-note decay envelope, patch the Channel Ramp out to
Amp Volume and set the Amp Envelope for a fast attack and 100% sustain and short
release.

Preset PatchCords

Preset PatchCords give you real-time control of the Preset Modulators. There are 12
Preset PatchCords per preset with a source, a destination and an amount control.
The amount can be set from -100 to +100.
Modulation Sources
Off
Pitch Wheel
Mod Wheel (Modulation Wheel)
Pressure (Channel Pressure)
Pedal
MIDI Volume (Controller 7)
MIDI Pan (Controller 10)
Expression (Controller 11)
MIDI A-P
Footswitch 1
Flip-Flop Footswitch 1 (F' s witch 1 FF)
Footswitch 2
Flip-Flop Footswitch 2 (F' s witch 2 FF)
Thumbswitch
Flip-Flop Thumbswitch (T' s witch FF)
DC Offset
Channel Lag 1 & 2
Channel Ramp
60
Modulation Destinations
Off
Channel Lag 1 In
Channel Lag 1 Amount
Channel Lag 2 In
Channel Lag 2 Amount
Channel Ramp Rate
Post-FX Main Send
Post-FX Aux 1 Send
Post-FX Aux 2 Send
Post-FX Aux 3 Send
FX A Mod 1
FX A Mod 2
FX A Mod 3
FX A Mod 4
FX B Mod 1
FX B Mod 2
FX B Mod 3
FX B Mod 4
Proteus X Operation Manual