Table of Contents
Advertisement
7 - Effects
Proteus X Composer FX Template
Proteus X Composer FX Template
This is the effects architecture we have chosen to use for the Proteus X Composer bank.
We recommend that you use this scheme as a model for your own presets unless you
have special requirements. Preset effects and global effects can be used simultaneously
and you can use PatchMix DSP hardware effects by simply changing the Aux Output
routing.
The main effects are located in the Multisetup so that they can be shared by all presets.
This is the standard sidechain effects routing scheme found on all mixing boards.
Aux 1 = Reverb and Aux 2 = BPM Delay. MIDI controller K controls Reverb amount and
MIDI controller L controls Delay amount through the Preset PatchCords.
The diagram below shows the Proteus X Composer routing scheme.
Wet/Dry
Bypass
100%
wet
dry
Main
Aux 1
Voices
Aux 2
Aux 3
VOICE
Key Points
Voice
Aux 1, 2, 3 are turned fully down and are not used.
•
The Main Output is turned up full.
•
The Wet/Dry Mix is turned to full wet.
•
Preset
No effects are selected for Preset FXA/FXB. (To add a preset effect, just select one!)
•
The Main Output is turned up full.
•
Aux 1 and Aux 2 are initially turned down, but they are controlled by Preset Patch-
•
Cords connected to MIDI controllers K & L.
Aux 3 is turned down and is not used.
•
Multisetup
Aux 1 is routed to Reverb.
•
Aux 2 is routed to BPM Delay.
•
Important: All the Aux Outputs are set to EX Main (ASIO 1/2) and so are mixed
•
together before being sent to the Host computer.
108
Post FX
PRESET
Sends
Bypass
FX A
FX B
Off
Off
Off
L
Off
On/Off
Main
Aux 1
Reverb
Aux 2
BPM
Delay
Aux 3
Off
Not
Used
K
MIDI
Controllers
(Preset Cords)
Aux Outputs
EX Main
Aux 1
EX Main
Aux 2
EX Main
Aux 3
MULTI
Proteus X Operation Manual
EX Main
Advertisement
Table of Contents
