Twin - E-Mu ProteusX Operation Manual

Twin

The Twin utilizes two "tube" stages to simulate the overdrive response of a guitar
amplifier. Separate gain controls allow you to precisely control the amount of soft
clipping from each "tube" stage. A three-band tone control between the two stages and a
presence control after the 2nd stage allow you to precisely contour the overdrive
frequencies. Set the amount of distortion using the Volume and 2nd Stage Gain
controls, then adjust the tone using the Treble, Mid and Bass controls. The Compression
control smooths out the timbrel changes and the Output Level control sets the final
volume of the effect.
In
Volum
Compression
Parameter Description
Volume This parameter controls the overdrive amount on the 1st "tube"
and thus the amount of distortion generated.
Master Volume This parameter sets the output volume level and has no effect on
the tone.
Treble Allows you to adjust the high frequency content between the two
"tubes".
Mid Allows you to adjust the mid frequency content between the two
"tubes".
Bass Allows you to adjust the low frequency content between the two
"tubes".
2nd Stage Gain This parameter controls the overdrive amount on the 2nd "tube"
and thus, the amount of distortion generated.
Presence Allows you to adjust the mid frequency content at the output of
the 2nd "tube".
Pan Sets the left/right pan position of the processed sound.
Range: -100% to +100%
Compression Tubes have a certain amount of natural "soft" compression. This
controls how much compression is applied by both tubes.
Modulation Parameters
Wet/Dry Mix
•
Gains 1 & 2
•
Master Volume
•
Pan
•
E-MU Systems
Tone
Controls
Bass
Mid
Treble
2nd
Stage Gain
Presence
Filter
Presence Master
Pan
Volume
Effects Descriptions
L
Out
R
7 - Effects
133