Table of Contents
Advertisement
Application planning
4.1 Checking incoming goods
The shock indicator monitors any G-forces acting during the entire transport. If the charging
station is subjected to unacceptably high G-forces during transport, the shock indicator is
triggered. The indicator tube shows that the tolerance limit for G-forces has been exceeded
by red coloring.
Perform a visual inspection of the shock indicator as follows:
1. Check whether there is a shock indicator on the transport packaging.
2. Check whether the glass tube in the middle of the indicator has turned red.
3. Report any red colored or missing indicator to the carrier immediately.
The carrier must confirm the red colored or missing indicator on the receipt.
Check the overall transport packaging
After you have checked the shock indicator, continue checking the incoming goods with the
visual inspection of the overall transport packaging.
4.1.3
Unpackaging the charging station
Depending on the transport route, the forwarding agent delivers the charging station in
different transport packaging.
Removing packaging for road transport
To remove the packaging, proceed as follows:
1. Remove transport film
2. Remove the edge protection strips
3. Remove spacers
Remove packaging for air transport
To remove the packaging, proceed as follows:
1. Remove the side walls of the packaging one-by-one as follows:
– Unscrew the screws in the side panel
– Remove side panel
2. Remove the cover of the transport packaging
40
SICHARGE UC 100, UC 200, UC 300, UC 400, UC 600, UC 800
Operating Instructions, 10/2022, A5E50828019-AC
Advertisement
Table of Contents
