Table of Contents
Advertisement
Maintenance and service
10.1
Safety instructions
To ensure the safety of persons and property during maintenance and servicing of the charging
station, observe the following safety instructions.
Qualified personnel
Only qualified and trained persons may work on SICHARGE UC. Only a qualified and trained
electrician may work on SICHARGE UC.
Electric shock from live parts
Electrical systems have live parts during operation. If the system has not been disconnected
from the power supply before maintenance work is performed inside the station, death,
serious injury or damage to property may occur.
• Only perform maintenance and service work inside the station when the charging station
• Observe the five safety rules for electrical work (Page 12).
Electrical shock due to residual charges in capacitors
After switching off the power supply to the charging station, the capacitors begin to discharge.
Live parts remain under dangerous electrical voltage for up to 10 minutes during discharging.
Touching the live parts can lead to death or serious injury.
• Wait 10 minutes after switching off the power supply.
• Ensure that the charging station is not live.
• Only then should you start work on the charging station.
Fall arrester
Use approved protective equipment to protect persons, components and tools against falling
from a working height of 1 m.
Falling parts
When working at an elevated height, watch out for falling parts, cables or plugs.
SICHARGE UC 100, UC 200, UC 300, UC 400, UC 600, UC 800
Operating Instructions, 10/2022, A5E50828019-AC
WARNING
WARNING
is disconnected from the power supply.
WARNING
WARNING
WARNING
10
151
Advertisement
Table of Contents
