Figure 8 Rear View Of The Contivity 5000 - Nortel Contivity 5000 Installing

Figure 8 shows the back of the Contivity 5000. All interface cables and the power
cords attach to the rear of the gateway.

Figure 8 Rear view of the Contivity 5000

2 power supplies
Reset switch
Power switch
Dual AC receptacles
Note: When one or both AC power cords are connected to power
outlets, the system is set to standby mode with voltages applied to the
system motherboard. The power switch on the back of the Contivity
5000 is a system activation switch and is not directly connected to AC
power or to the system power supplies. This switch controls the
motherboard, which turns the system on via processor initiation.
Connect the interface cables to the Contivity 5000 in this order:
1 Connect the appropriate RJ-45 cables to the built-in LAN ports (10/100BASE
and 1000BASE-T) on the gateway (see
For more information about the cables that you can connect to these ports, see
"System ports" on page
2 If you plan to connect a terminal or PC to the gateway, connect the serial cable
shipped with the gateway to the serial port (see
3 Connect all other cables to the ports on the installed interface cards.
If you ordered optional interface cards, connect the cables for these interfaces
to the ports.
Chapter 2 Cabling the gateway and turning the power on 35
10/100/1000
Ethernet
Serial port
LAN port
94.
6 PCI slots
1 2 3 4
64/100 32/33
10/100
Ethernet
LAN port
Figure 8 on page 35).
Figure 8 on page
Installing the Contivity 5000
5 6
64/133
10893EA
35).