Installing Dimms - Nortel Contivity 5000 Installing

78 Chapter 4 Installing option cards and field replaceable units

Installing DIMMs

To install or replace a DIMM:
1
2
3
4
5
6
7
8
9
315990-D Rev 00
Shut down the Contivity 5000 using the Web GUI or the command line
interface and then unplug it as described in
or replace hardware" on page
Danger: Turn off the Contivity 5000 and unplug it before you attempt
to install DIMMs.
Remove the front bezel from the chassis, then remove the chassis from the
equipment rack (see
Remove the top cover from the chassis (see
cover" on page 64).
Attach the antistatic wrist strap that was shipped with the Contivity 5000 (see
"Attaching the antistatic wrist strap" on page
If you are replacing a DIMM, remove the installed DIMM as follows:
a
Press down the locking lever on either side of the DIMM
b Pull the DIMM up to remove it from the slot.
Caution: Replace and install a pair of DIMMs of the same type in a
single memory bank. See
page 76.
Install the new DIMM by pressing down the locking lever on either side of the
empty DIMM slot (Figure
Place the new or replacement DIMM in the slot
Use the alignment keys to properly position the DIMM in the slot. The
alignment keys enforce the proper installation of the DIMM.
Press the DIMM firmly into the socket.
Pull up the locking lever on either side of the DIMM to snap it into position.
63.
"Removing the front bezel and top cover" on page
"Considerations for installing DIMMs" on
34).
"Shutting down the system to add
"Removing the front bezel and top
68).
(Figure
(Figure 34).
64).
34).