Figure 4 Installing The Shelf In The Equipment Rack - Nortel Contivity 5000 Installing

28 Chapter 1 Installing the Contivity 5000 chassis
2

Figure 4 Installing the shelf in the equipment rack

3
4
5
6
315990-D Rev 00
Position the rack-mount shelf inside the rack as shown in
To ease the shelf into the rack, tilt it slightly or squeeze its sides together
gently before moving it into the rack.
Rack edge
Flange
Align the holes in the shelf with holes in the front of the rack.
Make sure that the support flange snaps into place
Insert one of the supplied 1/2-in. truss screws through the top hole on each
side of the shelf into the hole in the rack and tighten the screws
Go to the rear of the equipment rack and attach the two rack-mount brackets
to the shelf and to the equipment rack as follows:
a
If the holes in the rack's vertical supports are not threaded, attach a cage
nut in four locations at the rear of the rack.
Figure 4.
CS260003B
(Figure 4).
(Figure 4).