74 Chapter 4 Installing option cards and field replaceable units
Figure 29 Installing and removing an option card
Option card
8
9
315990-D Rev 00
Make sure that the card is seated firmly in the slot. If the card is not seated
properly, it will not work.
Motherboard
Replace the screw that secures the card to the slot
Replace the top cover on the chassis (see
a
Hold the cover at an angle and slide it onto the chassis.
b Using a screwdriver, insert and tighten the 4 screws that secure the cover
to the chassis.
Warning: The Contivity 5000 weighs approximately 50 pounds (23 kg).
Two people are needed to install the gateway in the equipment rack.
Rear of unit
Option card slots
Figure 24 on page
Filler panel screw
CS2600017B
(Figure
29).
66).