80 Chapter 4 Installing option cards and field replaceable units
11 With two people facing the front of the equipment rack, set the Contivity 5000
12 Insert one of the 1/2-in. truss screws through the bottom hole on each side of
13 Replace the front bezel (see
Replacing a power supply
The Contivity 5000 ships with dual hot-swappable 350 W power supplies installed
in the chassis. The power supplies share the load of providing power to the
Contivity 5000. If one power supply fails, the second one provides all the power
required by the gateway.
The power supplies are accessible from the rear of the chassis
Figure 35 Location of the Contivity 5000 power supplies
LEDs
315990-D Rev 00
on the rack-mount shelf.
the shelf into the hole in the rack and tighten the screws (see
page
28).
a
Hold the bezel by its two handles and push it onto the chassis.
b Using the screwdriver, tighten the 2 screws to secure the bezel to the
chassis.
Figure 30 on page
10893EB
Figure 4 on
75).
(Figure
35).