Dual V.35 Wan Interface Card; Figure 57 Dual V.35 Wan Interface Card - Nortel Contivity 5000 Installing

Dual V.35 WAN interface card

The dual V.35 WAN interface card has two DB26 connectors that provide the
signals needed to interface to V.35 equipment.
Figure 57 shows the dual V.35 WAN interface card.

Figure 57 Dual V.35 WAN interface card

Note: The dual V.35 WAN interface card is no longer available for
purchase. Version 5.0 is the last release of Contivity software that will
support the dual V.35 WAN interface card.
You need a DSU/CSU (digital service unit/channel service unit) between the
WAN connection and the gateway. This section documents the connector and
cables used with V.35 WAN synchronous adapters.
If you build your own V.35 DTE cables, observe the following guidelines:
• All connector hoods must be metal.
• Braid must enter and make contact inside the metal connector hood.
• V.35 conn strain relief must be conductive.
Included in the accessory box are two cables to attach to the V.35 connectors.
These cables enable the WAN adapter to function as DTE (data terminal
equipment).
Appendix A Technical specifications 115
Installing the Contivity 5000
CS260016A