10/100Base Ethernet Lan Port; Table 20 1000Base-T Ethernet Port Pinouts - Nortel Contivity 5000 Installing

Table 20 provides the 1000BASE-T Ethernet port pinouts.

Table 20 1000BASE-T Ethernet port pinouts

12345678
CS260010A

10/100BASE Ethernet LAN port

The system board provides one 10/100BASE Ethernet LAN interface on the rear
of the chassis. This LAN interface, which accommodates an RJ-45 straight-
through cable, is generally used for Web management. Depending on whether you
will use the interface for 10BASE-T or 100BASE-TX operation, select cables for
the interface as follows:
• 100BASE-TX connections require Category 5 twisted-pair wire. The
100BASE-TX specification supports 100 Mb/s transmission over two pairs of
Category 5 twisted-pair Ethernet wiring: one pair each for transmit and
receive operations.
The maximum recommended cable segment length is 100 meters between a
100BASE-TX repeater and a workstation (due to signal timing requirements).
This wiring scheme complies with the EIA 568 wiring standard.
• 10BASE-T connections can use Category 3, 4 or 5 twisted-pair wiring.
Appendix A Technical specifications 95
Pin
1
2
3
4
5
6
7
8
Description
TP0+
TP0-
TP1+
TP2+
TP2-
TP1-
TP3+
TP3-
Installing the Contivity 5000