Table of Contents
Advertisement
Front passenger airbag disabled
1 Adjust the seat cushion inclination so that the front edge of the
seat cushion is in the highest position and the rear edge of the seat
cushion is in the lowest position.
2 The vehicle is equipped with automatic front passenger airbag
shutoff. The PASSENGER AIR BAG OFF indicator lamp must be lit.
X Not suitable for children in this weight category.
U Suitable for child restraint systems of the "Universal" category in
this weight category.
L Suitable for semi-universal child restraint systems according to
the table in "Recommended child restraint systems", or if the vehi-
cle and the seat are listed in the child restraint system manufactur-
er's vehicle model list.
UF Suitable for forward-facing child restraint systems of the "Univer-
sal" category in this weight category.
Securing the child restraint system with the seat
1, 2
U, L
belt on the rear seat
When fitting a belt-secured child restraint system,
observe the following:
O Always comply with the manufacturer's
installation and operating instructions for the
child restraint system used.
O Remove the upper section of the seat back-
rest before folding the lower section of the
seat backrest forward.
O Children up to a height of 1.35 m can travel
in the child restraint system on the rear
seats. Children 1.35 m to 1.50 m tall should
travel in a suitable child restraint system on
the front passenger seat.
O When using a rearward-facing child restraint
system: if fitting a child seat requires you to
do so, close the lower section of the seat
backrest.
O Before opening or closing the soft top, the
child restraint system on the rear bench seat
must be removed.
O For a child restraint system in the "Universal"
or "Semi-Universal" category, make sure that
Occupant safety
the system has been approved for the vehicle
seat.
Observe the notes under "Suitability of seats
for attaching belt-secured child restraint sys-
tems" (
page 74).
/
O When using a weight category 0/0+ baby
car seat and a weight category I rearward-
facing child restraint system on a rear seat:
adjust the front seat so that the seat does
not touch the child restraint system.
O The backrest of the forward-facing child
restraint system must, as far as possible, be
resting on the seat backrest of the rear seat.
O If the head restraint of the child seat cannot
be fully extended when it is installed in the
vehicle, this will result in restrictions on the
maximum size setting for child restraint sys-
tems in weight category II or III.
Contact with the roof when the head
restraint is fully extended and locked in place
will not result in any restrictions on use.
O The child restraint system must not be put
under strain between the roof and the seat
cushion and/or be fitted facing the wrong
75
Advertisement
Table of Contents
