Folding back
Ensure that there are no objects behind the
#
seat backrest. Otherwise, the seat backrest
may not be able to engage.
Swing back the seat backrest.
#
Ensure that the seat backrest is engaged.
#
If the seat backrest is not engaged, this will be
shown on the multifunction display on the
instrument cluster. A warning tone will also
sound.
The seat will automatically move to the stored
position.
Switching the seat heating on/off
& WARNING Risk of burns due to repeatedly
switching on the seat heating
Repeatedly switching on the seat heating can
cause the seat cushion and seat backrest pad-
ding to become very hot.
In particular, the health of persons with limited
temperature sensitivity or a limited ability to
react to high temperatures may be affected or
they may even suffer burn-like injuries.
Do not repeatedly switch on the seat
#
heating.
To protect against overheating, the seat heating
may be temporarily deactivated after it has been
switched on repeatedly.
* NOTE Damage to the seats caused by
objects or documents when the seat
heater is switched on
When the seat heater is switched on, over-
heating may occur due to objects or docu-
ments placed on the seats e.g. seat cushions
or child seats. This could cause damage to the
seat surface.
Make sure that no objects or documents
#
are on the seats when the seat heater is
switched on.
Requirements:
The power supply is switched on.
R
Seats and stowing 115
Press button
1
repeatedly until the desired
#
heating level is set.
Depending on the heating level, up to three
indicator lamps will light up. If all indicator
lamps are off, the seat heating is switched off.
%
The seat heating will automatically switch
down from the three heating levels after 8, 10
and 20 minutes until the seat heating
switches off.