Table of Contents
Advertisement
enclosed space without sufficient venti-
lation.
& WARNING Risk of injury by becoming
trapped when opening and closing a
garage door
When you operate or program a garage door
with an integrated garage door opener, per-
sons can become trapped or struck by the
garage door if they stand within its range of
movement.
Always make sure that nobody is within
#
the range of the garage door's move-
ment.
Before programming the garage door opener, park
the vehicle outside the garage. Make sure that the
vehicle is switched on but not started.
Requirements:
The vehicle has been parked outside the
R
garage or outside the range of movement of
the door.
The vehicle is switched on.
R
The vehicle has not been started.
R
%
The garage door opener function is always
available when the vehicle is switched on.
Press and hold button 1,
2
#
wish to program.
Indicator lamp
4
flashes yellow.
%
It can take up to 20 seconds before the indi-
cator lamp flashes yellow.
Release the previously pressed button.
#
Indicator lamp
Point remote control
#
1 cm to 8 cm towards button 1,
Press and hold button
#
5
until one of the following signals appears:
Indicator lamp
R
ously. Programming is complete.
Indicator lamp
R
ming was successful. Additionally, syn-
chronisation of the rolling code with the
door system must be carried out.
If indicator lamp
#
green: repeat the procedure.
Release all of the buttons.
#
%
The remote control for the door drive is not
included in the scope of delivery of the garage
door opener.
or
3
that you
Synchronising the rolling code
Requirements:
The door system uses a rolling code.
R
Driving and parking 183
4
continues to flash yellow.
5
from a distance of
2
or 3.
6
of remote control
4
lights up green continu-
4
flashes green. Program-
4
does not light up or flash
Advertisement
Table of Contents
