Editing Ports; Setting A Basic Configuration - Nortel Passport 8600 Configuring

80 Chapter 4 Configuring and graphing ports

Editing ports

To edit a single port or multiple ports:
1
2
Note:
not available for selection.
When you edit multiple ports, some options are not available, and other options appear
to be available even though the dialog box or tab is not applicable. When a dialog box or
tab does not apply for a given port, NoSuchObject is displayed.

Setting a basic configuration

You can set options for a basic port configuration through the Interface tab in the
Port dialog box
Note:
applicable. For example, on the Interface dialog box for a port, tabs for layer 3 (routing)
functions would appear if Device Manager were accessing a Passport 8600 module.
To set a basic configuration:
1
2
314723-D Rev 01
Select the port or ports you want to edit.
Do one of the following:
• Double-click a port.
• Right-click a port. On the shortcut menu, choose Edit.
• From the Device Manager menu bar, choose Edit > Port.
• On the Device Manager toolbar, choose the Edit Selected button.
When you edit a single port, dialog boxes and tabs that are not applicable are
(Figure 20 on page
Additional tabs and screen entries for module-specific functions appear when
On the device view, select a port or multiple ports.
From the Device Manager menu bar, choose Edit > Port.
The Port dialog box opens with the Interface tab displayed
page 81).
81).
(Figure 20 on