Table of Contents
Advertisement
Standard Network Mode Configuration
Using Standard Network Mode configuration requires a valid IP address from your ISP. To
configure Standard Network Mode, cancel the Wizard, and log into the SonicWALL using
"192.168.168.168" for the IP address. Click Network, and then Standard from the Network
Addressing Mode menu. Enter all of the appropriate IP information and click Update for the
configuration to take effect on the SonicWALL.
Log into the SonicWALL Management Interface
Once the SonicWALL restarts, contact the SonicWALL Management interface at the new
SonicWALL LAN IP address. Enter the User Name "admin" and enter the new
administrator password to log into the SonicWALL.The Status page is displayed.
The Status tab displays the following information:
•
SonicWALL Serial Number - the serial number of the SonicWALL unit.
•
Number of LAN IP addresses allowed with this license - number of IP addresses that
can be managed by the SonicWALL
•
Registration code - the registration code generated when the SonicWALL is registered
at <http//www.mysonicwall.com>.
•
SonicWALL Active time - the length of time in days, hours and minutes that the
SonicWALL is active.
•
Firmware version - shows the current version number of the firmware installed on the
SonicWALL.
•
ROM version - the version number of the ROM.
Performing the Initial Configuration Page 33
Advertisement
Table of Contents
