Table of Contents
Advertisement
command from the list. If you do not see your command listed, select Other, and enter
the command in the field.
4. If the phone number for your ISP is busy, you can configure the number of times that the
SonicWALL modem attempts to connect in the Dial Retries per Phone Number field.
The default value is zero (0).
5. Enter the number of seconds between attempts to redial in the Delay Between Retries
(seconds) field. The default value is five (5) seconds.
6. Click Update to add the dial-up profile to the SonicWALL.
Configure Modem Settings
7. Select your manual dial-up profile as the Primary Profile.
8. Select None as the Secondary Profile.
9. Select the modem speaker volume from the Speaker Volume menu.
10. Click Connect to dial your ISP. When the modem has connected to the ISP, the button
text changes to Disconnect. To end the connection, click Disconnect. To dial-up
manually, log onto the Management station, and click Modem. Click Configure, and then
click Connect.
If you attempt to dial-up your ISP while the WAN Ethernet connection is active, a warning
message is displayed:
Click OK to begin dialing the ISP, or Cancel to return to the current status.
Tested Internet Service Providers
The following Internet Service Providers (ISPs) have successfully tested with the TELE3 SP:
Page 46 SonicWALL TELE3 SP Installation Guide
ISP
Additional Chat
Script Required?
AT&T
No
MSN
No
Earthlink
No
High Stream
No
Advertisement
Table of Contents
