Table of Contents
Advertisement
•
Test
Lights up when the SonicWALL TELE3 SP is first powered up and performing diagnostic
tests to check for proper operation. These tests take about 90 seconds. If the Test LED
remains lit after this time, the software is corrupt and must be reinstalled.
SonicWALL TELE3 SP Back Panel
The SonicWALL TELE3 SP back panel is shown below, followed by a description of each item.
Cooling Vents
5VDC,2A
Power input
Reset Switch
The SonicWALL TELE3 SP Back Panel Description
•
Power Input
Connects to the external power supply that is provided with the SonicWALL TELE3 SP. The
use of an Uninterruptible Power Supply (UPS) is recommended to protect the SonicWALL
TELE3 SP against damage or loss of data due to electrical storms, power failures, or power
surges.
•
Reset Switch
Erases the firmware and resets SonicWALL TELE3 SP to its factory clean state. This can be
necessary if the administrator password is forgotten, or the firmware has become corrupt.
•
CLI (Command Line Interface) Port
DB-9 RS-232 Serial port allows out of band management of the SonicWALL TELE3 SP using
a v.90/v.92 US Robotics external modem or a null-modem cable.
•
(2) Twisted Pair (10Base-T, 100Base-T) Ethernet Ports
(2) Auto switching 10Mbps/100Mbps Ethernet ports provide connectivity for both Ethernet
and Fast Ethernet networks. The Ethernet ports connect the SonicWALL TELE3 SP to the
LAN and WAN using Twisted Pair cable with RJ45 connectors.
Page 68 SonicWALL TELE3 SP Installation Guide
10Mbps/100Mbps
LAN Ethernet Port
CLI Port
10Mbps/100Mpbs
WAN Modem Port
WAN Ethernet Port
Advertisement
Table of Contents
