Setting Up A Management Station - SonicWALL TELE3 SP Installation Manual

5. Checking Link LEDs
Power
Modem
The WAN Link LED, and the LAN Link LED light up when the SonicWALL is properly connected
to the LAN and WAN port of your computers. The Modem LED lights up only when the TELE3
SP has an active dial-up connection.
Important: You may have to switch the red crossover cable with the standard grey cable
to establish a connection. Switch cables until a link is established. Switching between a
crossover cable and a standard cable does not damage your SonicWALL or your computer.

Setting Up a Management Station

To access the SonicWALL Management interface, you must set up a PC on your LAN to be in
the same subnet (network) as the SonicWALL. This computer is called the "Management
Station".
Accessing the SonicWALL from your PC
The SonicWALL is preconfigured to have an IP address of 192.168.168.168. To contact the
SonicWALL for the first time, you must change the Management Station IP address to
192.168.168.X where X is any number between 0 and 254, except 168 which is the SonicWALL
IP address. In this section, you configure your Management Station IP address to
192.168.168.200.
Page 12 SonicWALL TELE3 SP Installation Guide
WAN
LAN
Test