Configuring The Sonicwall In Nat Enabled Mode - SonicWALL TELE3 SP Installation Manual

Configuring the SonicWALL in NAT Enabled Mode

This section describes configuring the SonicWALL TELE3 SP in NAT mode. If you are assigned
a single IP address by your ISP, follow the instructions below. If you do not want to use NAT
Enabled mode for your network, see the Standard Network Mode configuration instructions
on page 33.
Note: Be sure to have your network information including your WAN IP address, subnet mask,
and DNS settings ready. This information is obtained from your ISP.
Accessing the Wizard
1. Open a Web Browser. Then type the default SonicWALL IP address, "192.168.168.168",
into the Location or Address field in the Web browser.
Note: Your Web browser must be Java-enabled and support HTTP uploads in order to fully
manage SonicWALL. Internet Explorer 5.0 and above as well as Netscape Navigator 4.0 and
above are recommended
The first time you access the SonicWALL Management interface, the SonicWALL Installation
Wizard automatically launches and begins the installation process.
Note: To bypass the Wizard, click Cancel. Then log into the SonicWALL Management Interface
by entering the User Name "admin" and the Password "password".
1. To configure your SonicWALL appliance, read the instructions on the Wizard Welcome
window and click Next to continue.
Page 16 SonicWALL TELE3 SP Installation Guide
.