Table of Contents
Advertisement
SonicWALL TELE3 SP Configuration Overview
There are four major sections to the configuration of the SonicWALL TELE3 SP
•
Management Station Configuration - In this step, configuring your computer to act as
the management station that establishes connectivity with the SonicWALL TELE3 SP.
•
SonicWALL TELE3 SP Configuration - Configuring the SonicWALL TELE3 SP to connect
to the Internet using the information from your ISP. If you are assigned a single IP address
from your ISP, enter it as the SonicWALL WAN IP address during the configuration.
•
Computer Configuration on the LAN - You must configure the computers on your LAN
to be on the same network as the SonicWALL after setting up your SonicWALL.
•
Modem Configuration - Configuring the modem for dialup access to your ISP is the last
part of configuring the TELE3 SP. You need the dialup access information from your ISP to
complete this section.
Management Station Configuration Overview
1. Change the TCP/IP settings of your work PC to be in the same subnet as the default IP
address of the SonicWALL. Typically, set your IP address to 192.168.168.200, subnet mask
255.255.255.0, and default gateway of 192.168.168.1.
2. Open your Web browser and enter the IP address, 192.168.168.168, into the Address field.
This is the default IP address of the SonicWALL.
SonicWALL TELE3 SP Configuration Overview
3. Use the Wizard to configure the SonicWALL TELE3 SP with the information from your ISP.
If you have a single IP address assigned to you, enter it into the SonicWALL WAN IP
Address field. Finish the steps as outlined by the Wizard.
4. Or, if you prefer not to use the Wizard, the user name of "admin" and the password
"password" can be used to access the Management interface.
5. Restart the SonicWALL.
Computer Configuration on the LAN Overview
6. Change your TCP/IP settings of your computer to be in the same subnet as the SonicWALL.
For example, if you are using the default address of the SonicWALL, 192.168.168.1,
configure the IP settings of your computer to be 192.168.168.X where X is a number
between 2 and 254.
Important: Do not set the computer IP address to be the same as the SonicWALL LAN IP
Address.
7. Open your Web browser and attempt to access a Web site on the Internet. If you can
access a Web site, you've successfully completed the configuration of your SonicWALL. If
you cannot access the Internet, recheck the IP settings of your computer and your
SonicWALL.
Introduction Page 7
Advertisement
Table of Contents
