Connecting With An Ipsec Vpn - Mitel 6600 User Manual

9. Enter your username and password, then click Connect. verify that he connection is
established properly by accessing an intranet site or a corporate network drive not
accessible outside the corporation).
Note: If you cannot connect, verify that your profile settings are correct (click
Properties in the login screen), and that your username and password are entered
correctly (they are usually case-sensitive). Verify also that an installed firewall is not
blocking your PPTP connection.

Connecting with an IPSec VPN

This section shows the procedure to use Your Assistant with an Internet Protocol Security
(IPSec) VPN, as tested with AT&T's VPN Net Client.
1. Connect to your ISP, and verify that the connection is established (access a public site
on the Internet).
2. Start your VPN, and verify that the VPN connection is established (access an intranet
site or corporate network drive not accessible from outside the corporation).
3. Send the VPN address to the PBX (see "Before Starting Your Assistant" on page 57).
4. Start Your Assistant.
Revision B
Appendix B—Using VPNs
63