Rrp 6-32 Finisher Transport Roller (Pl 20.7) - Xerox DOCUPRINT N4525 Service Quick Reference Manual

RRP 6-32 Finisher Transport Roller (PL 20.7)

Figure 1
Fig 6-24 Transport Roller
Removal
1. Remove the Jogging Cover (RRP 6-14).
2.
Remove the Front and Rear Top Cover (RRP 6-16).
3.
Remove the Front Cover-Open, Front Cover and Kit Stud Cover (RRP 6-17).
4.
Remove the Rear Cover (RRP 6-21).
5.
Remove the Top Cover-Left (RRP 6-22).
6.
Remove the Top Center Cover Assembly (RRP 6-23).
7.
Disconnect Path Sensor Harness (P/J 1).
8.
Remove the Input Path Sensor (RRP 6-29) and Bracket.
9.
Disconnect the wiring harness from seven clamps on the Drive Assembly
Bracket.
10. Remove the three screw securing the drive Assembly Bracket.
11. Remove the E-Ring, One-Way Gear and Bearing from the Inlet Roller Shaft on
the rear of the Finisher.
12.
Remove the Bearing (PL 20.7.12) that secures the shaft on the front side of the
Transport Roller.
13.
Lift up the Inlet Roller and move it toward the front so that the leading end of
the shaft on the side enters into the inside of the Finisher frame.
14.
Lifting up the shaft on the rear side of the Roller, pull it off.
6-740 DocuPrint N4525 Network Laser Printer - Service Guide
Figure 2
S4525-453