Xerox DOCUPRINT N4525 Service Quick Reference Manual page 39

Table 2-3 High Capacity Feeder Error Code Table
Displayed Error
Error Code
Message
Paper Jam C4-3
Clear Area A,
B
Clear Area C C5-0
Reset Tray 5
Paper Jam C5-1
Clear Areas B,
C
Paper Jam C5-2
Clear Areas A,
B, C
Paper Jam C5-3
Clear Area A,
B
Clear Area C C5-4
Reset Tray 5
Paper Jam C8-3
Clear Areas B,
C
Paper Jam C8-4
Clear Area C
Error Description
There is a paper jam between Paper Tray 4 and
the Registration Sensor.
Logic Control on the Print Engine Controller Board
sensed that when paper was fed from Tray 4, the
Registration Sensor did not actuate within then
specified time after the Tray 2 Take Away Sensor was
actuated.
There is a paper jam between paper Tray 5 and
the Tray 4 Take Away Sensor.
Logic Control on the Print Engine Controller Board
sensed that when paper was fed from Tray 5, the
Tray 4 Take Away Sensor did not actuate within the
specified time after the Tray 5 Feed Clutch was
actuated.
There is a paper jam between paper Tray 5 and
the Tray 3 take Away Sensor.
Logic Control on the Print Engine Controller Board
sensed that when paper was fed from Tray 5, the
Tray 3 Take Away Sensor did not actuate within the
specified time after the Tray 4 Take Away Sensor was
actuated.
There is a paper jam between Tray 2 Take Away
Sensor and Tray 3 Take Away Sensor.
Logic Control on the Print Engine Controller Board
sensed that when paper was fed from Tray 5, the
Tray 2 Take Away Sensor signal did not actuate
within the specified time after the Tray 3 Take Away
Sensor was actuated.
There is a paper jam between paper Tray 5 and
the Registration Sensor.
Logic Control on the Print Engine Controller Board
sensed that when paper was fed from Tray 5, the
Registration Sensor did not actuate within then
specified time after the Tray 2 Take Away Sensor was
actuated.
There is a paper jam between Paper Tray 5 and
the Tray 5 Take Away Sensor.
Paper fed from Tray 5 did not reach the Take-Away
Roller 5 Sensor within the specified time.
There is a problem with the Tray 3 Take Away
Sensor.
Logic Control on the Print Engine Controller Board
sensed the Tray 3 Take Away Sensor was on while
the printer was in standby.
There is a problem with the Tray 4 Take Away
Sensor.
Logic Control on the Print Engine Controller Board
sensed the Tray 4 Take Away Sensor was on while
the printer was in standby.
Volume 2 / High Capacity Feeder - Error Codes
Go to Unit/
RAP Page
No. No.
2-5 2-381
2-6 2-383
2-7 2-385
2-8 2-387
2-9 2-389
2-21 2-409
2-10 2-391
2-11 2-392
2-371