Fig 2-38 Tray 5 Feeder Assembly; Rrp 2-31Tray 5 Feeder Assembly (Pl 12.9) - Xerox DOCUPRINT N4525 Service Quick Reference Manual

RRP 2-31Tray 5 Feeder Assembly (PL 12.9)

Fig 2-38 Tray 5 Feeder Assembly

Removal
1. Remove Tray 3 and Tray 5 from the High Capacity Feeder.
2.
Remove the High Capacity Feeder Rear Cover (RRP 2-2).
3.
Remove Tray 5 Feed Clutch (RRP 2-13).
4.
Remove the E-ring securing the Feed Shaft Bearing to the High Capacity
Feeder frame, and slide the Bearing off of the shaft.
5.
Hold down the Stopper Link while you pull the Feeder Assembly to the front of
the High Capacity Feeder frame and remove from Feeder 5.
Replacement
1.
Hold down the Stopper Link while you insert the end of the Feed Shaft into the
opening in the rear of the High Capacity Feeder frame.
2.
Slide the Bearing into the Bearing cutout (refer to the figure).
3.
When both the Bearing is in place and the end of the Feed Shaft is through the
opening in the rear of the frame, release the Stopper Link.
The Pick Shaft should rest on top of the Stopper Link, and the Link should
secure the Feeder Assembly in place on the frame.
4.
Make sure the Paper Level Actuator tab on the Feeder is positioned in the
center of the arms of the Paper Level Sensor.
5.
Use and E-ring to secure the Bearing to the shaft.
6. Reinstall Tray 5 Feed Clutch (RRP 2-13).
7.
Reinstall the Rear Cover (RRP 2-2).
8.
Reinstall Tray 3 and Tray 5.
Volume 2 / High Capacity Feeder - RRPs
Feeder Assembly
S4525-227
2-453