Table 6-32 Error Code H5-92 - Xerox DOCUPRINT N4525 Service Quick Reference Manual

Table 6-32 Error Code H5-92 (cont'd.)
Step Actions and Questions
5 STAPLER TRAVERSE MOTOR REPLACEMENT
1. Replace the Stapler Traverse Motor (RRP 6-68).
2. Repeat the Stapler Traverse Motor Test in Step 3
above.
Does the Stapler Traverse Motor move the
Stapler Base slightly to the rear and back to
front and does it move freely without binding?
FINISHER MAIN BOARD REPLACEMENT
6
1. Replace the Finisher Main Board (RRP 6-84).
2. Repeat the Stapler Traverse Home Position Sensor
Test in Step 1 above.
Does the display read "Not Home" when the
Stapler Head is at the fron limit of its travel
(sensor not blocked) and "Home" when
inboard of the front limit (sensor blocked)?
3. Repeat the Stapler Traverse Motor Test in Step 3
above.
Does the Stapler Traverse Motor move the
Stapler Base slightly to the rear and back to
front and does it move freely without binding?
4. Test the Stapler by sending a stapling job to the printer.
Does the Stapler function correctly?
7 The following Finisher components and areas are
associated with this specific problem. One or more of
these components or areas may have failed partially or
completely. If you cannot isolate this problem using the
steps in this Repair Analysis Procedure, replace each
component or troubleshoot each area listed below, one at
a time, until you isolate and solve the problem.
Finisher Main Board (RRP 6-84)


Print Engine Controller Board (RRP 1-72)


Broken or damaged components within the


Stapler area, Compiler area, or along the paper
path
Wiring and connectors linking the components.


6-706 DocuPrint N4525 Network Laser Printer - Service Guide
Yes No
Problem Go to step 6
solved
Problem Replace the
solved Print Engine
Controller
Board (RRP
1-72) &
retest. If still
NO, go to
step 7.