Xerox DOCUPRINT N4525 Service Quick Reference Manual page 87

Removal
1.
Lock the two front High Capacity Feeder casters.
2. Disconnect the High Capacity Feeder interface cable from P613 located at the
rear of the base printer.
3.
Remove Tray 2 from the base printer.
4.
Open Tray 3 and remove the two thumbscrews securing the Left and Right
Docking Brackets to the High Capacity Feeder frame, then remove the
brackets.
The following step requires the printer to be lifted. The printer is
Warning
very heavy and requires two people to lift it. Do not attempt to lift
the printer by yourself.
5.
Lift the printer off of the High Capacity Feeder
6.
Set the printer on a level and stable surface.
Replacement
1. Position the High Capacity Feeder and lock the two front casters.
2.
Remove Tray 2 from the base printer.
The following step requires the printer to be lifted. The printer is
Warning
very heavy and requires two people to lift it. Do not attempt to lift
the printer by yourself.
3.
Lift the printer and position it a few inches above the base printer.
4.
Align the three positioning holes in the bottom of the base printer with the three
metal position posts in the top of the High Capacity Feeder.
5.
Slowly lower the printer onto the High Capacity Feeder.
6.
Open Tray 3.
7.
Reinstall the Left Docking Bracket between the High Capacity Feeder and the
printer (as shown in the figure).
8.
Use one thumbscrew to secure the Left Docking Bracket.
9.
Reinstall the Right Docking Bracket between the High Capacity Feeder and the
printer (as shown in the figure).
10.
Use one thumbscrew to secure the Right Docking Bracket.
11.
Close Tray 3.
12.
Reinstall Tray 2.
13. Reconnect the High Capacity Feeder interface cable to P613 located at the
rear of the base printer.
Volume 2 / High Capacity Feeder - RRPs 2-419