Fig 2-32 Tray 4 (Cont'd) - Xerox DOCUPRINT N4525 Service Quick Reference Manual

Removal
1.
Slide out Tray 5.
2. Remove the Rear Cover (RRP 2-2).
3.
Remove the High Capacity Feeder Left Cover (RRP 2-3)
4.
Open the Left Door C Assembly.
5.
Remove the Spring that is located on the left side of the Inner Chute (Figure 1).
6.
Remove the two screws securing the Inner Chute to the High Capacity Feeder
frame, and remove the Inner Chute.
7.
Disconnect P/J211 from Tray 3 Feed Clutch.
8.
Disconnect J211 and J213 from the Bracket (PL 12.4.8) (Figure 2), and free the
wire harness from the harness clips.
9.
Remove the two screws securing the Bracket to the High Capacity Feeder
frame, and remove the Bracket.
10.
Remove the E-ring securing Gear 22T to the Take Away Roller shaft (Figure
3)z
11.
Hold on to Gear 22T as you slide Tray 4 Take Away Roller toward the front of
the High Capacity Feeder.
12.
Remove Gear 22T and the Bearing.
13.
Remove Tray 4 Take Away Roller.

Fig 2-32 Tray 4 (cont'd)

Figure 3
Volume 2 / High Capacity Feeder - RRPs
S4525-221
2-447