RRP 6-34 Inlet Chute Assembly (PL 20.7)
Fig 6-26 Inlet Chute Assembly
Removal
1.
Remove the Jogging Cover (RRP 6-14).
2.
Remove the Front and Rear Top Cover (RRP 6-16).
3.
Remove the Rear Cover (RRP 6-21).
4.
Remove the Front Cover-Open, Front Cover and Kit Stud Cover (RRP 6-17).
5.
Remove the three screws securing the Drive Assembly Kit Bracket and move to
access the Gear (PL 20.7).
6.
Remove the E-Ring, Flange (PL 20.7) and Gear (PL 20.7) to acess the rear
screw for the Inlet Chute-Assembly.
7.
Remove two screws that secure to the Finisher from the Chute Assembly-Inlet.
8.
Pull the Chute Assembly-Inlet off the Finisher toward the left.
Replacement
1.
Reverse the above procedure.
6-744
DocuPrint N4525 Network Laser Printer - Service Guide
S4525-455