Table of Contents
Advertisement
Ethernet Configuration
By default, the Kaleido-RCP2 is shipped with DHCP enabled, so it will automatically be
assigned an IP address by a DHCP server.
• If no DHCP server can be found, the Kaleido-RCP2 will default to its static IP address.
• The time-out period before the Kaleido-RCP2 defaults to its static address is about 1
minute. To speed up the initialization, disable the DHCP option.
• The default static IP address is 10.0.3.191, but this can be changed.
• If you need to operate with a fixed IP address, you must use the Configuration menu to
disable DHCP and set up the correct IP address, Network Mask and Gateway.
• To access Kaleido rooms located in other subnets, the Kaleido-RCP2 must be
configured with the appropriate unicast IP addresses.
Room Selection
Before you can use your Kaleido-RCP2 to operate a Kaleido multiviewer system, you must
select the room in which to operate. Use the Configuration menu to access the list of
available rooms and select the one you wish to control. See Selecting a Room on page 6 for
details.
• Note: To log on to a room that is part of a Kaleido system configured in a different
subnet, the Kaleido-RCP2 must be configured with the appropriate unicast IP
addresses.
Configuration Menu
Resources for setting up the Kaleido-RCP2 to operate multiviewers are available through
the Kaleido-RCP2's Configuration menu. The current menu selection is shown on the LCD
display. To access the menu press and hold the ENTER button until the ESC button lights up,
and then use the keys to navigate, as indicated below.
2
8
ENTER
ESC
• Note: These keys are lit when menu access is enabled.
Move up
Move down
Access the submenu, or select the displayed value
Go back to the previous menu level, or cancel a value
selection
Kaleido-RCP2
Installation and Operation Manual
13
Advertisement
Table of Contents
