Table of Contents
Advertisement
Chapter 4 provides configuration instructions for the NV9649.
Summary
Summary . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 17
Adding a Panel to an NV9000 Configuration . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 17
NV9649 Panel Configuration Page(s) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 19
Button Definitions . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 46
Tally (GPIO) Window . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 76
Global Navigation . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 76
This chapter addresses configurers. Operators and other persons not interested in NV9649
configuration need not read this chapter.
Summary
The NV9649 is a relatively simple panel. It has 28 function buttons in 2 sections, a small
display area, a knob for device selection, and a GPIO (tally) interface.
At the rear of the panel, a DB25 connector supports 8 tally inputs and 4 tally outputs.
NV9000-SE Utilities is the software with which to configure the NV9649. Figure 4-4,
following, shows the default NV9649 panel configuration page from NV9000-SE Utilities.
Adding a Panel to an NV9000 Configuration
You must create configurations for the NV9649 using NV9000-SE Utilities. We assume that
you are familiar enough with NV9000-SE Utilities that you can understand the following
material. It is not difficult material, but some of the concepts might not be familiar to
everyone.
It takes only a few seconds to add a new panel configuration.
Configuration
17
Advertisement
Table of Contents
