GRASS VALLEY KALEIDO-RCP2 Installation And Operation Manual page 17

Action
Press and hold the ENTER
button until the ESC button
lights up to access the
Configuration menu.
Press 8 once to go to the
ETHERNET OPTIONS
submenu.
Press ENTER to open the
Ethernet parameter menu.
Press 8 to go to the next
option in the menu (Press 2
to return to the previous
option.)
Press ENTER again to select
this option and display the
current IP address.
You can move the cursor to
the next
digit position by pressing
the space key.
Use the DEL key to move the
cursor back to the previous
position.
Use the digit keys to change
the current value. Once you
pressed a digit key, the
cursor moves to the next
position.
When done, press ENTER to
confirm the address, or ESC
to cancel the change and go
back to the previous menu
level.
Press ESC twice to exit the
Configuration menu.
Note: If you changed any of
the network parameters (IP
address, subnet mask or
gateway), the Kaleido-RCP2
unit will reboot.
When you change the DHCP mode, the device must be restarted for the new option to take
effect. This is done automatically but only after you exit the Configuration menu. You can
LCD indication
Configuration
ROOM SELECTION
Configuration
ETHERNET OPTION
ETHERNET OPTIONS
DHCP
ETHERNET OPTIONS
IP ADDRESS
IP ADDRESS
010.000.003.191
The cursor blinks,
alternating between a black
square and the digit.
IP ADDRESS
192.168.000.010
The cursor blinks,
alternating between a black
square and the digit.
ETHERNET OPTIONS
IP ADDRESS
RMC
(the current room)
Kaleido-RCP2
Installation and Operation Manual
Other buttons
Digit keys 2 (UP) and 8
(DOWN), and the
ENTER and ESC
buttons are lit; other
digit keys are dimmed
All digit keys are lit as
well as the ENTER, ESC,
DEL and space key.
All buttons are
dimmed.
17