Table of Contents
Advertisement
Kaleido-RCP2
Enabling/Disabling the Kaleido-RCP2 User Interface
Action
Press 8 repeatedly to scroll
the list until you reach the
position you wish to log on
to, and then press ENTER to
select the new position.
Type the password using the
digit keys (up to 8 digits),
and then press ENTER.
Enabling/Disabling the Kaleido-RCP2 User Interface
The PANEL ENABLE button cycles the Kaleido-RCP2 between ENABLE and DISABLE modes.
In the DISABLE mode
• The PANEL ENABLE LED is flashing
• All other keys on the Kaleido-RCP2 are disabled (LEDs off).
• The LCD display is off.
• Any peripherals (e.g. mouse, keyboard) connected to the Kaleido-RCP2's USB ports are
also disabled.
The purpose of the panel enable function is to lock the user interface of the remote, thus
avoiding any accidental access to the Kaleido system.
Resetting the Kaleido-RCP2
To reset the Kaleido-RCP2
• Press ENTER + ESC + DEL simultaneously to restart the device.
• Disconnect and reconnect the Kaleido-RCP2's Ethernet cable to power cycle the device.
• The device will be reset automatically in case of software or hardware failure of its
internal controller.
24
LCD indication
Enter password:
Enter password:
****
(one asterisk appears for
each digit you type)
If the password is valid, the
following message displays
for 2 seconds:
Access granted
and then:
RMC
TC01
If the password is wrong, the
following message displays
for 2 seconds:
Access is denied
and then:
RMC
TC01
Other buttons
Digit buttons are lit as
well as the ENTER and
ESC buttons
Dimmed (depending
on the Kaleido system's
configuration)
Lit (depending
on the Kaleido system's
configuration)
Advertisement
Table of Contents
