Table of Contents
Advertisement
Once you exit the Configuration menu, the device will restart.
Here are the default parameter values:
DHCP
IP address
Subnet mask
Gateway
Unicast IP addresses
In addition, the current room and login position are erased from the Kaleido-RCP2 memory.
Action
Press and hold the ENTER
button until the ESC button
lights up to access the
Configuration menu.
Press 8 three times to go to
the FACTORY DEFAULT
submenu.
Press ENTER to open the
FACTORY DEFAULT
submenu.
Press ENTER to select the
RESTORE option, or press
ESC to return to the previous
menu level without
restoring the factory values.
Press ENTER again to restore
the factory defaults.
Press ESC once to reboot the
Kaleido-RCP2.
Updating the Kaleido-RCP2 Firmware
Firmware updates for the Kaleido-RCP2 are issued occasionally, usually with the release of a
new version of the Kaleido-X Software. The firmware update package, including the
Enable
10.0.3.191
255.255.0.0
0.0.0.0
All three host IP address
parameters set to 10.0.3.70 and
disabled by default
LCD indication
Configuration
ROOM SELECTION
Configuration
FACTORY DEFAULT
FACTORY DEFAULT
RESTORE
Configuration
FACTORY DEFAULT
The LCD screen is blank after
reboot.
Kaleido-RCP2
Installation and Operation Manual
Other buttons
Digit keys 2 (UP) and 8
(DOWN), and the
ENTER and ESC
buttons are lit; other
digit keys are dimmed
All buttons are
dimmed.
19
Advertisement
Table of Contents
