Ip And Ethernet Configuration - GRASS VALLEY OCP 400 User Manual

3.3.3 IP and Ethernet configuration

For the OCP to operate in a network environment it must have a unique identification. By
default, an IP address is assigned automatically. To set the IP address manually use the IP
CONFIG and ETH CONFIG submenus.
Menu
IP Config
page 1
IP Config
page 2
Menu
Ethernet
Config
page 1
OCP 400 Operational Control Panel User's Guide (v12.0)
Selections Function
IP Mode IP address assignment
Apply Sets IP mode
Subnet Mask Subnet mask address
—
IP Byte 1 IP address 1st byte
IP Byte 2 IP address 2nd byte
IP Byte 3 IP address 3rd byte
IP Byte 4 IP address 4th byte
Selections Function
Eth Speed Ethernet speed setting
Duplex Ethernet duplex-mode setting
—
—
Chapter 3 - Setup
Level Possible values
F Auto, Manual
F Press button to activate the new
IP settings
F 255.255.0.0
F 1..250 (192)
F 0..255 (168)
F 0..255 (0)
F 1..254 (2)
Level Possible values
F 10 Mbit, 100 Mbit, Auto
F Full, Half, Auto
23