Setting An Ip Address, Subnet Mask And Gateway - GRASS VALLEY KALEIDO-RCP2 Installation And Operation Manual

Kaleido-RCP2

Setting an IP Address, Subnet Mask and Gateway

address allocation). In our example, we suppose that the DHCP option is enabled, and must
be disabled. This task is performed by using the Configuration menu.
Action
Press and hold the ENTER
button until the ESC button
lights up to access the
Configuration menu.
Press 8 once to go to the
ETHERNET OPTIONS
submenu.
Press ENTER to open the
Ethernet parameter menu.
Press ENTER again to see the
current DHCP status.
Press 8 to go to the DISABLE
option (Press 2 to go back to
the previous selection.)
Press ENTER to select this
option, or press ESC to
cancel. In either case, you
will return to the previous
menu level.
Press ESC twice to exit the
Configuration menu.
Note: If you changed the
DHCP parameter, the
Kaleido-RCP2 unit will
reboot.
When you change the DHCP mode, the device must be restarted for the new option to take
effect. This is done automatically but only after you exit the Configuration menu. You can
make other changes using the Configuration menu, and only exit, once you are done with
the changes.
Setting an IP Address, Subnet Mask and Gateway
The table below shows how to set a fixed IP address for a Kaleido-RCP2 unit. As an example,
the IP address will be changed from 10.0.3.191 to 192.168.0.10. This task is performed by
using the Configuration menu.
• Note: The method is the same for the Subnet Mask and Gateway menus.
16
LCD indication
Configuration
ROOM SELECTION
Configuration
ETHERNET OPTION
ETHERNET OPTIONS
DHCP
DHCP
ENABLE
DHCP
DISABLE
ETHERNET OPTIONS
DHCP
RMC
Other buttons
Digit keys 2 (UP) and 8
(DOWN), and the
ENTER and ESC
buttons are lit; other
digit keys are dimmed
All buttons are
dimmed.