Configuration And Connection; Dip Switch Configuration - GRASS VALLEY 6026 Series Quick Setup Manual

6026 Series Quick Setup Guide

Configuration and Connection

Step 1: Select Control System
Control panel modes are set using DIP switch 6. See table below:
Step 1: Select Control System
Control panel modes are set using DIP switch 6.
See table below
Step 3: Connect Power
Plug cable into 2A fused IEC
socket

DIP Switch Configuration

Note: DIP switches not identified below can be set either up or down.
DIP switches configure the Control
System, Communications Type, and
GPIO Override.
Switch
3
6
10
[1]
Not currently used
Step 4: Setup Comms
Connect the appropriate cable to a comms port (serial or Ethernet) and configure the port address
- Standard RS232/485 pinout Serial Cable
- Standard CAT-5 10/100 BASE-T straight-through or crossover Ethernet cable
Function
GPIO—Overrider Input
Control System
Communications
Step 2: Select Comms Type
Set DIP switch 10:
Switch
Position
Up
Normal
6026777 and 6027778
panels on a Nebula
controller
RS485
3
UP = RS485 (serial)
DOWN = Ethernet
DIP Switches
Down
Button mimic [1]
All other panel types and
controllers
Ethernet