Epson WF-M21000 Series User Manual page 520

Administrator Information
Name
Scan to Cloud
Scan to Compuer (when
using Document Capture
Pro Server)
Related Information
"Setting a Shared Network Folder" on page 493
&
"Configuring a Mail Server" on page 489
&
Using Document Capture Pro Server
By using Document Capture Pro Server, you can manage the sorting method, saving format, and forwarding
destination of a scanning result executed from the printer's control panel. You can call and execute a job previously
registered on the server from the printer's control panel.
Install it on the server computer.
For more information on Document Capture Pro Server, contact your local Epson office.
Setting Server Mode
To use Document Capture Pro Server, set up as follows.
1. Access Web Config and select the Scan/Copy tab > Document Capture Pro.
2. Select Server Mode for Mode.
3. Enter the address of the server with Document Capture Pro Server installed on it for Server Address.
Enter between 2 and 255 characters in either IPv4, IPv6, host name or FQDN format. For FQDN format, you
can use alphanumeric characters in ASCII (0x20-0x7E) and "- " except for at the beginning and end of the
address.
4. Click OK.
The network is re-connected, and then the settings are enabled.
Scanning From a Computer
Install the software and check that the network scan service is enabled to scan via a network from the computer.
>
Settings to Use the Printer
Settings
Printer registration to Epson
Connect
Contact registration to Epson
Connect
Server mode setup for
Document Capture Pro
>
Preparing to Scan
Location
Device
Epson Connect service
Device
520
Requirement
Internet connection
environment
User and printer
registration to Epson
Connect service
IP address, host name, or
FQDN for the computer
that Document Capture
Pro Server is installed on