Configuration; Using The J-Web Interface - Juniper SRX300 Series User Manual

High memory gateway interface modules reference
Hide thumbs Also See for SRX300 Series:
Table of Contents

Advertisement

Related
Documentation
1-Port T1/E1 Mini-Physical Interface Module (SRX-MP-1T1E1-R) Basic Configuration

Using the J-Web Interface

Copyright © 2017, Juniper Networks, Inc.
set security zones security-zone trust interfaces se-1/0/0.0 host-inbound-traffic protocols
all
Set security policies:
6.
set security policies default-policy permit-all
1-Port Serial Mini-Physical Interface Module (SRX-MP-1SERIAL-R) Overview on page 15
1-Port Serial Mini-Physical Interface Module (SRX-MP-1SERIAL-R) Hardware
Specifications on page 16
1-Port Serial Mini-Physical Interface Module (SRX-MP-1SERIAL-R) LEDs on page 16
To enable the 1-Port T1/E1 Mini-Physical Interface Module (Mini-PIM) installed on the
services gateway, you must configure the basic settings for the PIM. You can perform
the configuration tasks for this using either the J-Web interface or the CLI.
Using the J-Web Interface on page 73
Using the CLI on page 74
To perform basic configuration for the 1-Port T1/E1 Mini-Physical Interface Module
(SRX-MP-1T1E1-R) and to configure network interfaces for the services gateway using
the J-Web interface:
In the J-Web interface, select
1.
The Interfaces page displays and lists the network interfaces present on the services
gateway, along with configuration information (if configured).
Select the interface name (
2.
Enter the details and click
to the port and assign it to a security zone, other than the Null zone. If there are no
security zones listed, proceed to the next step to add a security zone.
Add a security zone to the interface:
3.
Select
Configure>Security>Zones/Screens
a.
Add or select a security zone other than Null; for example,
b.
to the zone.
For Host Inbound Traffic-Zone, set the following:
c.
System Services=
Chapter 11: Configuring Mini-Physical Interface Modules
Configure>Interfaces
) and click
t1-1/0/0 or e1–1/0/0
. To use the port on the Mini-PIM, assign an IP address
OK
.
Allow All
.
Add > Logical Interfaces
. Assign the interface
Trust
.
73

Advertisement

Table of Contents
loading

This manual is also suitable for:

Srx550Srx300Srx320Srx340Srx345

Table of Contents