Using The Cli - Juniper SRX300 Series User Manual

SRX300 Series and SRX550 High Memory Gateway Interface Modules Reference

Using the CLI

76
Add a security zone to the interface:
3.
Select
Configure>Security>Zones/Screens
a.
Add or select a security zone other than Null; for example,
b.
to the zone.
For Host Inbound Traffic-Zone, set the following:
c.
System Services=
Protocols=
Allow All
Click to save changes, and select
OK
d.
and other pending changes.
To use the port on the Mini-PIM, you must also set security policies. Select the following
4.
settings:
Select
a. Configure>Security>Security Policy
Select
b. Global Options > Policy Options
Set Policy Action: Default Policy Action=
c.
Click to save changes, and select
d. OK
and other pending changes (if any).
For more information, in the J-Web interface, select
To perform basic configuration of the 1-Port VDSL2 Annex A Mini-PIM and to configure
network interfaces for the services gateway with the CLI:
Verify that the 1-Port VDSL2 interface is installed on the device:
1.
show chassis hardware
Verify the status of the interface:
2.
show interfaces terse
Assign the port an IP address:
3.
set interfaces pt-1/0/0 unit 0 family inet address interface address/destination prefix
Add or select a security zone; for example, Zone1:
4.
set security zones security-zone trust interfaces pt-1/0/0.0 host-inbound-traffic
system-services all
Add or select security zones for host inbound traffic options protocols:
5.
.
Allow All
Commit>Commit
.
Permit-All
Commit>Commit
Configure>Interfaces
. Assign the interface
Trust
to apply the configuration
to apply the configuration
and click
Copyright © 2017, Juniper Networks, Inc.
.
Help