Related
Documentation
16-Port Gigabit Ethernet XPIM Basic Configuration
Related
Documentation
Copyright © 2017, Juniper Networks, Inc.
user@host> show interfaces terse
Assign the interface an IP address:
4.
[edit]
user@host# set interfaces interface-name unit 0 family inet address interface
address/destination prefix
Add or select a security zone; for example, Trust:
5.
[edit]
user@host# set security zones security-zone trust interfaces ge-0/0/x.0
host-inbound-traffic system-services all
where x is less than or equal to 16
Add or select security zones for host inbound traffic protocol options:
6.
[edit]
user@host# set security zones security-zone trust interfaces ge-0/0/x.0
host-inbound-traffic protocols all
where x is less than or equal to 8
Set security policies:
7.
[edit]
user@host# set security policies default-policy permit-all
8-Port Gigabit Ethernet SFP XPIM Overview on page 29
8-Port Gigabit Ethernet SFP XPIM Components on page 30
8-Port Gigabit Ethernet SFP XPIM Hardware Specifications on page 31
8-Port Gigabit Ethernet SFP XPIM LEDs on page 31
8-Port Gigabit Ethernet SFP XPIM Supported Transceivers on page 32
8-Port Gigabit Ethernet SFP XPIM Network Interface Specifications on page 34
To enable the 16-Port Gigabit Ethernet XPIM installed on your services gateway, you
must configure its properties. You can perform the same configuration tasks provided in
"8-Port Gigabit Ethernet SFP XPIM Basic Configuration" on page 88
interface or the CLI configuration editor. In addition, you can configure a wider variety of
options that are encountered less frequently.
16-Port Gigabit Ethernet XPIM (PoE) Overview on page 35
16-Port Gigabit Ethernet XPIM (PoE) Components on page 36
Chapter 12: Configuring Gigabit-Backplane Physical Interface Modules
using the J-Web
89