Faceplate; Table 52: Hot-Swappable Component Descriptions For Gpims - Juniper SRX300 Series User Manual

SRX300 Series and SRX550 High Memory Gateway Interface Modules Reference
Removing a Blank Gigabit-Backplane Physical Interface Module Faceplate
Installing a Blank Gigabit-Backplane Physical Interface Module Faceplate
102

Table 52: Hot-Swappable Component Descriptions for GPIMs

Number Component
1 STATUS LED
2 ONLINE/OFFLINE
button
To maintain proper airflow through the services gateway, leave blank faceplates in place
over slots that do not contain Gigabit-Backplane Physical Interface Modules (GPIMs).
Do not remove a blank faceplate unless you are immediately installing a GPIM in the
empty slot.
To remove a blank faceplate:
Using a Phillips (+) screwdriver, loosen the captive screws on each side of the blank
1.

faceplate.

Using a flat-blade (–) screwdriver, gently pry out one side of the faceplate and pull
2.
it out.
NOTE: When installing a blank GPIM faceplate, make sure that the padded
side of the faceplate is facing up.
To maintain proper airflow through the services gateway, install blank faceplates in slots
that do not contain Gigabit-Backplane Physical Interface Modules (GPIMs).
To install a blank faceplate:
Align the captive screws on the blank faceplate with the screw holes on the chassis.
1.
Using a Phillips (+) screwdriver, tighten the captive screws on each side of the blank
2.
faceplate until the faceplate is flush with the chassis.
Description
The STATUS LED has the following indicator s:
Steady green indicates that the GPIM is functioning
normally.
Steady yellow indicates that the GPIM is starting up,
running diagnostics, or going offline.
Steady red indicates that the GPIM has failed.
Off indicates that the GPIM is not powered on, is offline,
or is not configured.
NOTE: You need not press this button when installing a GPIM.
The services gateway automatically recognizes when a GPIM
has been inserted into a slot.
Copyright © 2017, Juniper Networks, Inc.